Installation & Maintenance
Tools Required:
Torque wrench (10–15 Nm), fuel line disconnect tool, OBD-II scanner.
Steps:
Depressurize the Fuel System:
Disconnect the battery and relieve fuel pressure using the OBD-II scanner.
Pump Replacement:
Remove the rear seat or access panel to reach the fuel tank.
Disconnect electrical connectors and fuel lines, then unscrew the locking ring counterclockwise.
Install the 31110-2W950 assembly, ensuring the seal is properly seated, and tighten the locking ring to 40–50 Nm.
Post-Installation Checks:
Reconnect the battery, prime the fuel system, and test for leaks. Clear fault codes and perform a road test
Torque wrench (10–15 Nm), fuel line disconnect tool, OBD-II scanner.
Steps:
Depressurize the Fuel System:
Disconnect the battery and relieve fuel pressure using the OBD-II scanner.
Pump Replacement:
Remove the rear seat or access panel to reach the fuel tank.
Disconnect electrical connectors and fuel lines, then unscrew the locking ring counterclockwise.
Install the 31110-2W950 assembly, ensuring the seal is properly seated, and tighten the locking ring to 40–50 Nm.
Post-Installation Checks:
Reconnect the battery, prime the fuel system, and test for leaks. Clear fault codes and perform a road test
